SpeedsealLife Kit Test Update

0
SpeedsealLife Kit Test Update

255

In the Practical Sailor August 2010 issue’s Chandlery, we reported on the installation of a SpeedsealLife kit aboard one of our test boats, a Union 36 sloop powered by a 43-horsepower Beta Marine inboard. An improvement on the original Speedseal (PS, July 15, 2005), the SpeedsealLife is designed to extend the life of a water pump impeller, even in a run-dry situation.

The SpeedsealLife provides the rapid impeller access made famous by the original Speedseal, but it also incorporates a Teflon (PTEF) washer between the pump cover plate and a rotating brass disk that rotates with the pump impeller. In a typical water-cooled inboard engine, the seawater pump’s nitrile or neoprene impeller rubs against a stationary brass plate (the pump housing cover) and is lubricated by the water being pumped to cool the engine. In a run-dry situation, no lubrication means the impeller will be destroyed fairly quickly (2½ minutes on average) long before the engine overtemp alarm will sound.

We installed and began testing the SpeedsealLife in June 2010 and pulled it while winterizing our Chesapeake-based test boat this past winter. After two sailing seasons and 73 hours of engine use, there was no noticeable wear on the Teflon washer or the brass disc.

We then shipped both the washer and disc to the manufacturer for evaluation. The company concurred with our observations but recommended replacing both the disc and the washer every two years—a cost of $18—just to be on the safe side, so we heeded their advice.

SpeedsealLife kits—available for engines and generators, including Yanmar, Volvo, Johnson, and Beta, and Jabsco pumps—cost about $100, including shipping. Upgrade kits are also available for original Speedseal owners. According to the manufacturer, the kits come with the guarantee that any unsatisfied buyer will be given a full refund upon request.

Bottom line: The SpeedsealLife kit was easy to install and has held up well to two seasons of use. We recommend it for those looking for added engine protection.

Darrell Nicholson
Practical Sailor has been independently testing and reporting on sailboats and sailing gear for more than 50 years. Supported entirely by subscribers, Practical Sailor accepts no advertising. Its independent tests are carried out by experienced sailors and marine industry professionals dedicated to providing objective evaluation and reporting about boats, gear, and the skills required to cross oceans. Practical Sailor is edited by Darrell Nicholson, a long-time liveaboard sailor and trans-Pacific cruiser who has been director of Belvoir Media Group's marine division since 2005. He holds a U.S. Coast Guard 100-ton Master license, has logged tens of thousands of miles in three oceans, and has skippered everything from pilot boats to day charter cats. His weekly blog Inside Practical Sailor offers an inside look at current research and gear tests at Practical Sailor, while his award-winning column,"Rhumb Lines," tracks boating trends and reflects upon the sailing life. He sails a Sparkman & Stephens-designed Yankee 30 out of St. Petersburg, Florida. You can reach him by email at practicalsailor@belvoir.com.