How To Make a Dinghy Roller for Less Than $25

0
homemade dinghy roller

288

Making a portable set of dinghy wheels is relatively simple and inexpensive. Reader (and PS contributor) David Liscio sent us the following DIY how-to on dinghy-roller making, a timely Reader Workbench as we’ll be reviewing dinghy wheels in an upcoming issue. Email us your DIY project ideas at practicalsailor@belvoirpubs.com.

How To Make a Dinghy Roller for Less Than $25

288

According to Liscio, here’s what you’ll need:

• One pair of lawn mower wheels, 8-inch diameter with axle, washers, and wheel caps. ($10 or less)

• One pair of metal brackets to fasten axle to bottom of wood panel. ($3)

• 24 inches of rope, roughly a half-inch diameter; most any kind will do. ($1)

• Wood glue. ($2)

• One-quarter sheet of ¾-inch plywood. Marine grade is best but not necessary. (lumber yard surplus, $5)

• A dozen self-tapping stainless screws, 2-inch length. ($2)

1. Cut two panels of wood, one 14-by-11.5 inches, the other 14-by-9 inches. Also cut three spacers, 14-by-9 inches each.

2. Glue and screw one of the spacers to the larger of the two wood panels, making an L-shape. The screws should be started into the wood panel and enter the spacer.

3. Glue and screw the second smaller wood panel, only this time, start the screws into the spacer and then enter the wood panel. You should end up with what looks like a U-shape, with one wood panel slightly shorter than the other.

4. Screw the two axle brackets into place on the bottom spacer and fit the axle and wheels. Take one of the two remaining spacers, and glue and screw it directly onto the spacer already in place.

5. Then slip the entire device onto the transom of your dinghy to take a quick measurement. The wheels must not rub against the gunwale on the transom. To ensure clearance, screw the third spacer into place inside the U at a point that stops the transom from going any deeper.

6. Drill two holes into the larger (outside) wood panel for the rope. Tie knots in both ends of the rope. This will provide a carrying handle and an easy way to slip the device onto the transom, if the dinghy is stored in a rack or the back of your SUV. As you pull the dinghy from the rack, hold the device in place using the rope handle and slowly set down the dinghy.

David Liscio
Nahant, Mass.

Darrell Nicholson
Practical Sailor has been independently testing and reporting on sailboats and sailing gear for more than 50 years. Supported entirely by subscribers, Practical Sailor accepts no advertising. Its independent tests are carried out by experienced sailors and marine industry professionals dedicated to providing objective evaluation and reporting about boats, gear, and the skills required to cross oceans. Practical Sailor is edited by Darrell Nicholson, a long-time liveaboard sailor and trans-Pacific cruiser who has been director of Belvoir Media Group's marine division since 2005. He holds a U.S. Coast Guard 100-ton Master license, has logged tens of thousands of miles in three oceans, and has skippered everything from pilot boats to day charter cats. His weekly blog Inside Practical Sailor offers an inside look at current research and gear tests at Practical Sailor, while his award-winning column,"Rhumb Lines," tracks boating trends and reflects upon the sailing life. He sails a Sparkman & Stephens-designed Yankee 30 out of St. Petersburg, Florida. You can reach him by email at practicalsailor@belvoir.com.