Don’t Be Stung by O-Ring Sticker Shock

0

O-rings are smart to replace during service, but often OEM parts are not at hand when you need them and priced at the specialty level, even though most are quite generic.

SIZE

Careful measurement is required. The wrong major dimensions and they won’t fit the groove. Try to force it and it will either slide out of position or pinch when tightened, ruining the seal. Same with the cord diameter. Observe whether the old ring is flattened by compression, worn from wear, or swollen by material incompatibility.

COMPATIBILITY

The material must match the service. It may look like “rubber,” but it is actually one of several synthetic elastomers. Nitrile (buna-N) is the usual choice for diesel fuel, motor oil, and gasoline. EPDM is good for high temperature water service but falls apart within days when exposed to oil. Many applications, including heads, engines, and even cooling systems, see oil contact. As a result, nitrile is the common all-around choice, since it is more forgiving of mistakes. When in doubt, Google “chemical compatibility elastomers” and enter the liquid it needs to withstand.

DUROMETER READING

A hardness rating 70A is a typical durometer reading and suits nearly all applications. Harder (90A) and softer (50A) are available. If the O-ring seems hard, unless it is a very high pressure application, it’s probably just old.

PROFILE

Most O-rings are round, but there are also square and X profiles. These are also industry standard, although you won’t find them at the corner hardware or auto parts store. Try McMaster Carr, but you will have to buy a stack.

Recently a PS reader asked if an $0.85 Ace Hardware O-ring, with the same exact dimensions, would replace the $6.25 Perko diesel filter O-ring. A call to Ace confirmed the material is nitrile, so the short answer is, “Yes.” In fact, we found the same O-ring for $11.20 for a pack of 100 through McMaster Carr!

Check the dimensions and check material compatibility (nitrile is a good choice for most applications, including water and petroleum products). Then go generic.

Drew Frye
Drew Frye, Practical Sailor’s technical editor, has used his background in chemistry and engineering to help guide Practical Sailor toward some of the most important topics covered during the past 10 years. His in-depth reporting on everything from anchors to safety tethers to fuel additives have netted multiple awards from Boating Writers International. With more than three decades of experience as a refinery engineer and a sailor, he has a knack for discovering money-saving “home-brew” products or “hacks” that make boating affordable for almost anyone. He has conducted dozens of tests for Practical Sailor and published over 200 articles on sailing equipment. His rigorous testing has prompted the improvement and introduction of several marine products that might not exist without his input. His book “Rigging Modern Anchors” has won wide praise for introducing the use of modern materials and novel techniques to solve an array of anchoring challenges.